If your Kenmore ice maker is not making ice then we have the best solutions to your problems.
How To Troubleshoot
The ice maker failing to freeze the water is often not due to a major fault in the parts but your negligence. Yes, you heard it right. More than half of the users do not know what they are doing wrong. The temperature might deteriorate due to several reasons.
Your settings:
The most suitable temperature to form ice inside your Kenmore ice maker is between the range of 0 to 5-degree Fahrenheit. The users usually lower the temperature to decrease the freezing time but this overdoes the whole thing, causing a jam in the chamber.
On the contrary, you would see people increasing the temperature to save power. This increase in temperature heats things up (which is not suitable for cooling).
Condenser coils:
The condenser coils are usually located on the rear side of your unit. This network of wires dissipates the heat energy from your ice maker to the surroundings.
These wires tend to get dirty over time, due to which the dissipation becomes harder for the condenser. As a result, the system has to put more effort into the cooling process.
Evaporator coils:
Make sure that there is no ice deposited o the stripper inside the cooling chamber. If there is ice on it then we would recommend you to call a technician as it would need repair.
The water pressure and supply
There are two things to keep in mind. The first thing is that the unit must receive an adequate amount of water to continue the freezing process, so you must make sure that there is no twist in the water line or the valve is opened to let the water in.
On the other hand, water pressure is also required to be maintained. Ensure that the supply line is not twisted and the pressure is over 200 psi.
The power button
There are times when you might overfill the ice compartment or adjust the space without much of a care. While doing so, there are high chances that the power button might get pushed and turns off.
The solution is as simple as the problem itself. Just locate the power switch and turn it back on.
The thermostat
The thermostat is one of the most important parts when it comes to cooling devices. There is a thermostat attached to the mold, where the ice is made. When the thermostat detects that the ice is frozen, it commands the mold to empty itself by ejecting cubes of ice and refilling itself with fresh water.
A fault in the thermostat would disturb the process immensely. The solution is to replace the thermostat. A faulty or repaired thermostat is heftier than a migraine.
Water filter
Kenmore advises its user to change the water filter every 6 months. The filter screens out all the impurities from the water, making the water fresh and easy to freeze.
A blockage in the filter does not stop the ice-making process entirely but it makes it inefficient and time-consuming. Check out Best aftermarket refrigerator water filter.
Jam in the chamber
The ice jam is a very common problem but that does not mean that it is difficult to deal with. Take a plastic spatula and start striking the unwanted ice. Make sure that you strike carefully, as vigorous stabs might cause damage to the ice maker.
Any other issue
If you have any other issue which does not lie in the above-mentioned solutions then you should call a professional to help you out. Here you can Check out LG French door refrigerator ice maker leaking water.